Thingiverse
Customizable Bed Level Calibration Test
by timfou
320
Downloads
156
Likes
0
Makes
A customizable model to test areas of your heatbed for proper first-layer printing.
**How to use:**
1) print the model
2) check that first layer "squish" is the same on all the circles
3) raise/lower the nozzle at the left, right, front or back of you bed to adjust
The included STL model has nine circles which are 0.3mm high as I tested with 0.2mm layers with a first layer printed at 150% (0.3mm) and I only wanted to lay down a single layer for this test.
You can customize this model to set your preferred height, circle diameter, number of circles and distance between circles.
**How to use:**
1) print the model
2) check that first layer "squish" is the same on all the circles
3) raise/lower the nozzle at the left, right, front or back of you bed to adjust
The included STL model has nine circles which are 0.3mm high as I tested with 0.2mm layers with a first layer printed at 150% (0.3mm) and I only wanted to lay down a single layer for this test.
You can customize this model to set your preferred height, circle diameter, number of circles and distance between circles.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
