Customizable Cable Chain with Snap-in top

Edit 3/25/3020: Added Interior and Exterior end pieces.

Original Post:

I've tried several cable chain designs on thingiverse but none of them were perfect for me, so I made this one. Its walls are a little beefier than others I've seen since they're at least 2mm.

It has two components, the chain link and the clasp. The clasp is printed separately so that it can be removed while laying cables and clipped in when all of the cables have been run. This is much easier in my experience than trying to fish cables through the cable carrier.

I've never had success doing print-in-place cable chains even though my printer is dialed in pretty well, so this one is intended to print one link at a time.Since everyone has printers with different tolerances I think this makes more sense than trying to fine-tune a print-in-place version that works for everybody.

The STL's I posted are for a cable chain with inner width 30mm and inner height 10mm. If you want a different size, go to this