Customizable candy dispenser

Module 2 SLides3D MODEL DESCRIPTIONServe your treats of all kinds in a fun way thanks to this great evolving and changeable treat dispenser!One dispenser, infinite possibilities!Print the common base parts, and choose the module you want to install in the central part of your dispenser from those available.But nothing is definitive. You can change the module at any time, in just a few seconds!Do you have several types of treats that you want to use with one dispenser? Print multiple tanks and close the ones you don't use with the tank cover.A video of the setup is coming soon.Module 2 slide available here: https://www.crealitycloud.com/model-detail/6633597be6946c4a5e280f023D PRINTING SETTINGSSome files need to be printed more than once. If the file name has an "x3" at the end, it means you need to print it in 3 copies.-Tank-Reservoir cap / Reservoir cover / Reservoir 1:Print flat in the original direction, without supports. It is recommended to use a translucent filament for best rendering and to see the treats from outside the dispenser.-Common base-Distributor base / Screw handle / Lower part / Upper part :Print flat in the original direction. It is not necessary to use supports, but if your printer has trouble printing the cantilever, you can activate the supports.Pillars x3 / Worm gear:Print in the original direction. Brackets are required to support the legs of the pillars, and the start of the worm. Lock the brackets to the threaded parts. You can activate a border if your grip on the tray is not optimal.-Module 1 Slide-Slide part 1 / Slide part 2:Print in the original direction, without supports. If your printer has trouble printing the overhang, supports may be needed (no supports on the threaded part).Full slide:Print in the original direction. Enable supports to support the bottom part of the slide only. No supports needed on the threaded portion.