Thingiverse
Customizable Card Case v3.0
von Hyperxion
0
Downloads
0
Likes
0
Makes
This is 3rd version of 2-slot card case i have designed. Print with support, 0.3mm layer height.
Supports are kind of tricky. You must set 100% density on contact layer, otherwise it is hard to remove supports. Cover is customizable, you can see some of my creations in photos. If you like this model, check out this page https://www.facebook.com/ddd.printED/ for more stuffs.
Supports are kind of tricky. You must set 100% density on contact layer, otherwise it is hard to remove supports. Cover is customizable, you can see some of my creations in photos. If you like this model, check out this page https://www.facebook.com/ddd.printED/ for more stuffs.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!