Thingiverse
Customizable eggs holder
von eugef
11
Downloads
13
Likes
0
Makes
Customizable eggs holder developed in OpenSCAD.
Open customizer to specify the matrix, the number of holders by length and width.
For example : 2x6, 6x6, 4x3, 1x1, etc... The base size will adjust. Just make sure if fits your printing bed size.
You can select between standard or minimalistic base (only supported for multi-row matrix, single-row always uses standard base).
You can also print only a footprint template to measure against your intended placement location.
No special printing preferences. No supports needed. No adhesion
Open customizer to specify the matrix, the number of holders by length and width.
For example : 2x6, 6x6, 4x3, 1x1, etc... The base size will adjust. Just make sure if fits your printing bed size.
You can select between standard or minimalistic base (only supported for multi-row matrix, single-row always uses standard base).
You can also print only a footprint template to measure against your intended placement location.
No special printing preferences. No supports needed. No adhesion
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
