Customizable Hex Wall Art

I needed something unique to fill an awkward space on my wall and nothing out there quite did it. So I made this! It’s a flexible set that lets you mix and match shapes and colors however you like.The hexagon panels are 30mm edge to edge and come in 10mm, 15mm, and 20mm depths.Clips are included for holding the panels together. The notch in the side is sized for a flat head screwdriver to pry one side of a clip up to help detach it.The cog-shaped bracket is for mounting, just attach it to your wall and slide the panel over the top. They come with a screw hole, but sticky tabs work as well depending on weight.The empty panel is intended as a frame for installing the bracket. Just pop out one of the panels, put the empty panel in it's place, attach the bracket to your wall, then replace the original panel.If you make something with this, I’d love to see it!____ Prints were tested using a Bambu P1s with Voxel PLA+ filaments.I recommend a resolution 0.2, 2 side and top layers, 3 bottom