Customizable Modular Keychain Spinner

I'm very excited to release our customizable spinners! I did a few of these for my clients but I didn't have an easy way to customize them. I always end up spending a lot of time in Fusion 360 just to change the logo. I also listed down some of the disadvantage in doing a print-in-place design like these.• The bottom print can get messy from stringing due to color changes• The bottom does not have the same texture as the top• having different color rings takes too much time to print on single extruder printers• If you make a mistake, you have to reprint the entire plate. (I had 2 hour power failure when I printed my own designs and I had just added the NFC cards. The print resumed when the power came back but it resulted in a layer shift and the middle ring did not spin)These modular spinner solves most of the problem listed above. The only disadvantage that I saw was that you'd have to print the parts in 3 different plates and assemble them. Below is a tutorial on how to a