Customizable Moon Lamp Stand

This is a base with battery, touch sensor, battery charger, and LED light for the Moon Lamp. It is designed to fit an 18650 Li ion battery, but it can be customised to any other size.

Parts used:
- 0.5W LED https://www.ebay.com/itm/10PCS-8MM-Straw-Hat-0-5W-LED-Light-Emitting-Diode-White-LED-High-Power-NEW/253677201181
- Touch sensor (The LED diode located on the sensor needs to be removed in order to make this work, otherwise it steals all the energy required for the transistor and therefore also for the main LED; the B jumper needs to be soldered) https://www.ebay.com/itm/10Pcs-TTP223-Touch-Key-Module-Capacitive-Settable-Self-lock-No-lock-Switch-Board/352537840349
- 10 Ohm resistor (other value can be used as well, I picked what I had at home. Higher value means higher light up time but lower light intensity and vice versa. Too low value can cause LED damage. Use value higher than 6.8 Ohm. Recommended range is 6.8 - 30 Ohm) https://www.ebay.com/itm/100PCS-1-4W-0-25W-1-Metal-Film