Thingiverse
Customizable Mounting Plate
door ragwafire
4
Downloads
0
Likes
0
Makes
I needed to mount the new power supply and controller to the back of my printer, but the holes didn't line up at all. So I designed this customizable mounting plate as a go-between.
#Customization:
The .scad file allow you to specify the diameter of each pair of holes, the spacing between those holes, the vertical spacing between the two pairs, the clearance around the holes, and the thickness of the plate.
It also allows you to add either a counter bore or a counter sink to each pair, ensuring you get a flush connection and that the screws don't pose a problem when attaching things directly to the plate.
When choosing parameters for your screwholes, especially the counter bore/sink, I would recommend consulting a standards guide to be sure your measurements are correct. The spec sheet I used when creating my plates can be found [here](https://www.electroimpact.com/Company/Standards/QMS-0003.pdf).
The distance between holes should be measured from the center of the hol
#Customization:
The .scad file allow you to specify the diameter of each pair of holes, the spacing between those holes, the vertical spacing between the two pairs, the clearance around the holes, and the thickness of the plate.
It also allows you to add either a counter bore or a counter sink to each pair, ensuring you get a flush connection and that the screws don't pose a problem when attaching things directly to the plate.
When choosing parameters for your screwholes, especially the counter bore/sink, I would recommend consulting a standards guide to be sure your measurements are correct. The spec sheet I used when creating my plates can be found [here](https://www.electroimpact.com/Company/Standards/QMS-0003.pdf).
The distance between holes should be measured from the center of the hol
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
