customizable net pot for hydroponics

customizable net pot for hydroponics.

I made those pots for my hydroponic setup wich is a recirculating DWC inside PVC pipes. The commercial sizes of 2" pots are too deep for my 100mm pipes, so I made a custom one with a lower height.

the customizable parameters are:

shell thickness
total height
height of the straight section(the upper part)
dimension of the upper brim
upper diameter (brim not included)
angle of the lower section
number of side holes
dimension of the side supports (how small are the holes)

print settings:

I printed them in PETG and sliced them in CURA
line width: 0.6mm works well, even on a 0.4mm nozzle, ideally the same as the thickness parameter
supports: no
cooling: 100%

if you get under extrusion it is probably due to the many retractions. Try increasing the retraction extra prime amount (on CURA). I am using 0.4mm^3 on a bowden setup