Thingiverse
Customizable Odroid-H2 case
by jhe2
31
Downloads
12
Likes
2
Makes
This is a customizable and easy to print case for the __Odroid-H2__, __Odroid-H2+__, __Odroid-H3__ and __Odroid-H3+__ single board computers.
The case can be configured to contain a 2.5" disk drive (with a height between 7 mm up to 15 mm). If you do not want to use a 2.5" disk at all, it can be disabled to reduce the case height. The Ordoid-H2 is attached with M3x30 screws and nuts. Screw sizes are configurable as well.
The case dimensions are 13x12x6.5 cm for the configuration with a 9.5 mm 2.5" disk.
For this configuration STL files are included. For all other configurations you can use the OpenSCAD Customizer.
The case can be configured to contain a 2.5" disk drive (with a height between 7 mm up to 15 mm). If you do not want to use a 2.5" disk at all, it can be disabled to reduce the case height. The Ordoid-H2 is attached with M3x30 screws and nuts. Screw sizes are configurable as well.
The case dimensions are 13x12x6.5 cm for the configuration with a 9.5 mm 2.5" disk.
For this configuration STL files are included. For all other configurations you can use the OpenSCAD Customizer.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
