Customizable Rokenbok Smartphone Mount

A customizable file to create a Rokenbok-compatible smartphone (e.g. iPhone) mount. Choose between having a male snap on the bottom or not.

Tested with the following setup:
*Printer: Replicator 2 (PLA)
*Layer height: 0.2mm

These designs are owned by Rokenbok Education (http://www.rokenbok.com) and published under license by kid*spark (http://www.kid-spark.org), a nonprofit corporation, for nonprofit and educational uses. Drawings of these designs are licensed under Creative Commons Attribution-NonCommercial-ShareAlike (BY-NC-SA) 3.0: http://creativecommons.org/licenses/by-nc-sa/3.0/ The drawings may be freely downloaded, modified, and used, providing that attribution is given to Rokenbok Education and the drawings are for non-commercial purposes. Any modified drawings are licensed under the same terms. The drawings are intended for educational and hobby uses only; 3D prints of these designs should not be considered toys or for use by children without adult supervision. The