Thingiverse
Customizable Spool Holder
por FilipHoertner
11
Descargas
4
Likes
0
Makes
This is a customizable spool holder for use with 608 bearings and an M8 threaded rod. You can customize this by using the Thingiverse Customizer or by downloading and changing the values in the .scad file (You can also use the method described in [this](https://www.thingiverse.com/thing:2812634) thing.).
To make this fit your filament spool, measure the hole diameter with something like a caliper and change the value "inner diameter" to your measured size. As my prints tend to shrink slightly I added 0.2mm to the diameter for a perfect fit. Also, you can change the value "bearing fit" to "Tight", which is actually the exact outer diameter of the bearings, but again, it didn't fit in my case, so i made the "Normal" fit value slightly bigger. I would recommend to only use the "Tight" fit if your printer is really well adjusted, but even in this case you would probably have to sand the bearing hole to make the bearing fit. The third value changes the position of the bearing from the in
To make this fit your filament spool, measure the hole diameter with something like a caliper and change the value "inner diameter" to your measured size. As my prints tend to shrink slightly I added 0.2mm to the diameter for a perfect fit. Also, you can change the value "bearing fit" to "Tight", which is actually the exact outer diameter of the bearings, but again, it didn't fit in my case, so i made the "Normal" fit value slightly bigger. I would recommend to only use the "Tight" fit if your printer is really well adjusted, but even in this case you would probably have to sand the bearing hole to make the bearing fit. The third value changes the position of the bearing from the in
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
