Thingiverse

Customizable Square Pipe Cap (fusion360) – Bild 1

Customizable Square Pipe Cap (fusion360) – Bild 2

Customizable Square Pipe Cap (fusion360) – Bild 3

Customizable Square Pipe Cap (fusion360) – Bild 4

Customizable Square Pipe Cap (fusion360)

von asimomagic

1.7k Downloads

1.4k Likes

2 Makes

Zum Modell

--- Hi, I designed a more versatile rectangular cap, see that too. https://www.thingiverse.com/thing:4875215 ---

This is a square pipe cap. It can handle various pipe side.
Customization is done by changing the parameters of fusion360 file (.f3d).
Try this cap once.
Click here for the round pipe version. https://www.thingiverse.com/thing:4795549

[Features]
-Customizable
-Fixed firmly
-Hard to break even if squeezed strongly with a wrench
-Easy to remove from the pipe
-Easy to print(no support)

[Design point]
Designed so that when the bolt is tightened, the bolt is parallel to the pipe. This enabled stable tightening.

[Bolt/Nut type to use]
type: CAP bolt and Nut M3 - M6
bolt length: The recommended screw length is equal to or greater than the pipe diameter.

[Customizable parameters]
-pipe inner side (min:8mm at M3, max: no limit)
-Flange side (normally same as pipe outer side)
-Flange thickness
-Flange chamfer
-screw size (M3, M4 ,M5, M6)
*Detailed sc

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Warum?

keine Supports

Ohne Supports Einteilig Hardware nötig

Supports 0/3

Zusammenbau 0/3

Einstellungen 2/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker