Thingiverse
Customizable stackable vase mode twist container
von radziwon
34
Downloads
26
Likes
0
Makes
It is stackable.
It is vase mode printable.
It is twist container.
C-C-C-Combo breaker!!! :)
Remix of "Customizable Satisfying Twist Container" with nut part and screw part stacked on top of each other with chamfer in the middle, and chamfer at the bottom.
Gap between screw and nut part depends on print quality, screw groove depth, and cross-section shape. Test fit when parts cooled down!
Meant as fast-to-print pill container, but any use goes. Cura print sequence "one at a time" recommended.
It is vase mode printable.
It is twist container.
C-C-C-Combo breaker!!! :)
Remix of "Customizable Satisfying Twist Container" with nut part and screw part stacked on top of each other with chamfer in the middle, and chamfer at the bottom.
Gap between screw and nut part depends on print quality, screw groove depth, and cross-section shape. Test fit when parts cooled down!
Meant as fast-to-print pill container, but any use goes. Cura print sequence "one at a time" recommended.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
