Thingiverse
Customizable Switch Guard
von S13_Mills
2
Downloads
1
Likes
1
Makes
An OpenSCAD rendition of my '2 out of 3 switch guard'.
You can choose the size of the faceplate, the number of switches to be covered, etc.
If you need a one-sided guard (like the original), create a 2-sided one, and simply rotate it so it sits on its side, then offset it in the Z-axis on your slicer (i.e. move the part you don't want to print below the build-plate).
You will need supports for the 'normal' orientation to get decent results on the holes.
You can choose the size of the faceplate, the number of switches to be covered, etc.
If you need a one-sided guard (like the original), create a 2-sided one, and simply rotate it so it sits on its side, then offset it in the Z-axis on your slicer (i.e. move the part you don't want to print below the build-plate).
You will need supports for the 'normal' orientation to get decent results on the holes.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!