Customizable tackle box

This is a mini tackle box with slide-in dividers. You can customize which dividers you want and how to place them. There are recesses in the lid of the box which should prevent stuff from shuffling around when you shake it. The interior area measures a bit more than 160mm x 80mm.

I guess you could use this box to store not-tackle too.


Printing:

Print everything without supports.

Box base/dividers: I printed at 0.2 mm layer height, 25% infill, 4 perimeters, in Extrudr Greentec Pro, so it could survive in a hot car.

Lid: Use a flexible filament. I used NinjaFlex, 0.2 mm layer height, 4 perimeters, 50% infill (though 100% is probably better). If you find any separation between perimeter and infill, you can use a soldering iron set to 200C to seal up the cracks.