Customizable VR gunstock

Here is a relatively more customizable yet sturdy VR gunstock that uses the same pipes as the Sanlaki design. I recommend the 6 inch pipes (https://www.amazon.com/dp/B07SSWYCGL?psc=1&ref=ppx_yo2_dt_b_product_details) rather than the 8 inch pipes for this design.

All joints have teeth that allow 7.5 degree angle adjustments. Each joint is put together with a M4 x 30 bolt and two M4 hex nuts (one wound on the bolt all the way through and one hammered into the knob.) A total of 7 M4 screws and and 14 M4 hex nuts are needed. Because of the teeth for angle adjustments you DO NOT need to over tighten, hand tight is sturdy enough. Overtightening with a wrench WILL have the nut rip right through the plastic so recommend printing the knobs instead of using a wrench on the M4 nuts. Also the knob helps to cover up the rough end of the bolt that may cut you. Small and large knobs are interchangeable.

Any file suffixed with -s means support is needed to print those.

Magnets (you may wan