Customizable Water Bottle Boot

Tired of denting your water bottles? Check out this customizable water bottle boot! It's great to keep your water bottle from getting scratches, dings, and dents. You can print it in TPU, PLA, ABS, or whatever else you have. However, I do recommend printing it in TPU so that it doesn't crack if you drop it. It's also a very easy print and only takes a little over 30 minutes to print.INSTRUCTIONS: PLA and hard plastic: To get the right fit on your water bottle, you'll want to measure your water bottle and then whatever you measurement you get, just add 0.3mm to it. This will allow the boot to come on and off but still fit tight. TPU and flexibles: Because TPU is very flexible, it doesn't any tolerance at all. So all you need to do is measure your water bottle and put in that measurement.Boost MeHelp support us by boosting! :)Social:Find us on Instagram hereFind us on TikTok here Other platforms DR3D is on:Find us on Thangs3D hereFind us on Printables here