Thingiverse
Fashion
Go to Model
Customizeable Chastity Key Safe
166
Downloads
125
Likes
1
Makes
A small safe to hold a key behind a numbered lock. It's easy to get the key out if you urgently need it, but obvious after the fact when the unique lock is broken.
Remixed from a previous design to make the text easier to edit, and widen the hole to fit more sizes of numbered locks. I've found [These locks](https://smile.amazon.com/gp/product/B07K86BM3M/) to work well, but if you're cheap you could probably melt a small loop of raw filament into a tamper-evident tag too.
There are some blank pre-labeled variants included, but you can also use Customizer or [Open SCAD](https://openscad.org/downloads.html) to enter your own text. The .scad source file is included.
### Print Settings
I printed at .2mm layer height in PETG, and changed the perimeters from 2 to 3 because the walls get a little thin here and could use the extra strength.
Remixed from a previous design to make the text easier to edit, and widen the hole to fit more sizes of numbered locks. I've found [These locks](https://smile.amazon.com/gp/product/B07K86BM3M/) to work well, but if you're cheap you could probably melt a small loop of raw filament into a tamper-evident tag too.
There are some blank pre-labeled variants included, but you can also use Customizer or [Open SCAD](https://openscad.org/downloads.html) to enter your own text. The .scad source file is included.
### Print Settings
I printed at .2mm layer height in PETG, and changed the perimeters from 2 to 3 because the walls get a little thin here and could use the extra strength.
Rhoboto also publishes on
37 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
