Thingiverse
Customizeable Pipe Bender (for Heatpipes)
von 3ddruckqueck
1.4k
Downloads
942
Likes
4
Makes
Parametric, fully 3D printable Pipe Bender I designed last Sunday to fight boredom and save 20€.
Bending radius should be more than 3 times the diameter of the heatpipe and no more than 90 degrees.
Three holes for up to 6mm, up to 8mm and up to 10mm heatpipe diameter.
Tolerance of 0.2mm worked fine for a Replicator 5th (no sanding nor drilling required).
Adjust it to your needs in the OpenScad file or with the Customizer.
I'll upload the .stl files for a radius of 30mm, you can change it to your specific value in the OpenScad file or with the Customizer.
Dimensions in [mm]
_______________________________________
Update1 (RC2.scad):
Rounded the bending lever for smoother results.
Update2 (RC3.scad):
Set the default back to r=30mm and updated the .stl
Update3 (RC4.scad):
Turned the lever 90 degrees again for easier printing of the axle mounting hole
Update4 (RC5.scad):
Bending lever is rounded only on the backside now as it should be
Update5 (RC6.sc
Bending radius should be more than 3 times the diameter of the heatpipe and no more than 90 degrees.
Three holes for up to 6mm, up to 8mm and up to 10mm heatpipe diameter.
Tolerance of 0.2mm worked fine for a Replicator 5th (no sanding nor drilling required).
Adjust it to your needs in the OpenScad file or with the Customizer.
I'll upload the .stl files for a radius of 30mm, you can change it to your specific value in the OpenScad file or with the Customizer.
Dimensions in [mm]
_______________________________________
Update1 (RC2.scad):
Rounded the bending lever for smoother results.
Update2 (RC3.scad):
Set the default back to r=30mm and updated the .stl
Update3 (RC4.scad):
Turned the lever 90 degrees again for easier printing of the axle mounting hole
Update4 (RC5.scad):
Bending lever is rounded only on the backside now as it should be
Update5 (RC6.sc
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!