Thingiverse
Customizer pipe adapter / hose fitting
von i-make-robots
385
Downloads
251
Likes
2
Makes
My dudes and dudettes! So many remixes, not one make? What the frick? Post me some sweet pics. And whatever you do, [don't look away from the nozzle](https://www.youtube.com/watch?v=H8yQhXDquII).
Friend asked me to make a hose fitting between his vacuum and his jigsaw. I built one [1](https://www.instagram.com/p/BpflQqtgnos/?taken-by=imakerobots) [2](https://www.instagram.com/p/Bpf5z8-g9m4/?taken-by=imakerobots) and then decided to invest in a solution that would help most people.
Customize your two nozzle diameters, the depth the nozzles can enter the fitting, and the wall thickness.
There is a small chamfer on the inside edge of each opening to make tight fits easier. There is a 0.5 lip to prevent vacuum suction pulling the hoses too far into the adapter.
The diagonal section between each hose fitting is 45 degrees to minimize support material.
I recommend you print 0.2mm diameter more than your hose to compensate for print quality. if you find the fit too loo
Friend asked me to make a hose fitting between his vacuum and his jigsaw. I built one [1](https://www.instagram.com/p/BpflQqtgnos/?taken-by=imakerobots) [2](https://www.instagram.com/p/Bpf5z8-g9m4/?taken-by=imakerobots) and then decided to invest in a solution that would help most people.
Customize your two nozzle diameters, the depth the nozzles can enter the fitting, and the wall thickness.
There is a small chamfer on the inside edge of each opening to make tight fits easier. There is a 0.5 lip to prevent vacuum suction pulling the hoses too far into the adapter.
The diagonal section between each hose fitting is 45 degrees to minimize support material.
I recommend you print 0.2mm diameter more than your hose to compensate for print quality. if you find the fit too loo
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!