Thingiverse
Cute SD Octopus Repaired
von Kyoxilbuzz
68
Downloads
42
Likes
8
Makes
Like a lot of persons here, i had a problem with the tentacle not printed well, as well as a weird extra width in the middle of the octopus body (i am using Repetier and Slic3r).
So, i put this under Netfabb, and voila! problem gone.
Look at the images of the paths to be convinced.
So, i put this under Netfabb, and voila! problem gone.
Look at the images of the paths to be convinced.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!