Thingiverse
Cutting Board Holder/Stand
par Ruffturn
0
Téléchargements
0
Likes
0
Makes
I needed some way of containing the flexible plastic cutting boards in our kitchen cabinet. They were constantly falling over or sliding down flat on the bottom of the cabinet. Simple design. I also included the supports ("Thermos Stand Connector", print two), that I glued (using 3dGloop!) to the back uprights to strengthen them, since this was printed flat. Otherwise, the upright back could snap off if a heavier cutting board was stored there.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !