Cuvette Surface Temp Probe Adapter

This is used to adapt a Vernier Surface Temperature Probe STS-BTA to a Cuvette used in Chemistry experiments. It uses #4x1/2" sheet metal screws to attach the cover plate which holds the wire in place.

The design has been compensated to allow for typical FDM printers but you still may need to make some fine adjustments with a file etc.

You should not need any support structure for the small tunnel on the underside. Most printers will easily span this small gap.

You can use a 5/64" drill to clear the small hole and a 3/32 drill in the smaller screw holes so the screw goes in more easily.