Cyber angel

Picture source/author: SandySarten @sandysarten Then used HueForge v0.8.1 to create the model. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.The Model is 150x150mm in size. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2.08mm and the Actual Depth is 2.08mm. It is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support. Filaments Used: PLA ******** Black Transmission Distance: 0.3PLA ****** + Orange Transmission Distance: 6PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA ****** Basic White Transmission Distance: 7This print uses 4 unique filaments Swap Instructions:Start with BlackAt layer #10 (0.88mm) swap to OrangeAt layer #13 (1.12mm) swap to Blue GrayAt layer #16 (1.36mm) swap to White for the rest.