Thingiverse
Cyclone Mini (Spinner)
von dottom22
22
Downloads
19
Likes
0
Makes
This is my take on a pocket casual fidget spinner. Uses the standard 608zz skateboard bearings. Bore of the model was cut at 22.3mm and should fit any 8x22x7 bearing.
Update 4/12/17: I have added two new versions. The Cyclone Mini V3 and V3-Tri. These are the same changes I have made to my Cyclone Micro. Divots to replace the nubs on the arms and a 3-armed version for extra weight and grip.
Update 4/12/17: I have added two new versions. The Cyclone Mini V3 and V3-Tri. These are the same changes I have made to my Cyclone Micro. Divots to replace the nubs on the arms and a 3-armed version for extra weight and grip.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
