Thingiverse
Cylinder Test
by antimix
12
Downloads
8
Likes
0
Makes
This object should be used to fine tune your slicer and printer.
I printed the famous 0.5mm thin wall ( http://www.thingiverse.com/thing:5573 ), and when the measures were OK I printed some cylinders, and discovered that the measure of the cylinders were wrong, but the box was OK. In order to fine tune the slicer I created this object.
It is a 40mm x 10mm x 3mm base with 6 cylinders on it, they are alternate, one with a hole, one not,with the following sizes: 3mm, 3mm, 4mm, 4mm, 5mm, 5mm.
Once printed, of course the cylinders diameters sizes should match, but unfortunately with most of the slicer settings they don't.
It is very small, so, if want to print it with PLA you need a very good cooling.
* This thing was made with Tinkercad. Edit it online https://tinkercad.com/things/4t3zb5XUih8
I printed the famous 0.5mm thin wall ( http://www.thingiverse.com/thing:5573 ), and when the measures were OK I printed some cylinders, and discovered that the measure of the cylinders were wrong, but the box was OK. In order to fine tune the slicer I created this object.
It is a 40mm x 10mm x 3mm base with 6 cylinders on it, they are alternate, one with a hole, one not,with the following sizes: 3mm, 3mm, 4mm, 4mm, 5mm, 5mm.
Once printed, of course the cylinders diameters sizes should match, but unfortunately with most of the slicer settings they don't.
It is very small, so, if want to print it with PLA you need a very good cooling.
* This thing was made with Tinkercad. Edit it online https://tinkercad.com/things/4t3zb5XUih8
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
