Thingiverse
Cylindric Spring
von BiGoK
3
Downloads
5
Likes
0
Makes
This is a small Spring which is very stiff.
It was printed with ABS but works with soft PLA too!
A layer height of 0.2mm works fine.
No support needed.
It was printed with ABS but works with soft PLA too!
A layer height of 0.2mm works fine.
No support needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
