Thingiverse
Cypress PSOC5 CYC8KIT-059 FluxEngine case
door hjalfi
3
Downloads
1
Likes
0
Makes
This is a clip-together case for a Cypress CY8CKIT-059 development board, with a cutaway to give access to the necessary pins to attach a floppy disk drive connector. It's suitable for making a FluxEngine USB FDD interface: see http://cowlark.com/fluxengine/ It may also be useful for other projects.
To make, print both STL files, flat side down. You don't need any support. The part with the holes in it is the top. The small USB connector goes in the small hole, and the large USB programming connector sticks out the other end. The board will clip in, and then the bottom will clip onto the top half. You don't need any fasteners. The clips are a bit rough and you may want to tidy them up with a razor blade, but (at least for my printer) it all holds together pretty well.
It is faintly possible that Cypress might redesign the board and move the components around, in which case the support bars might be in the wrong place. If this is the case, please get in touch.
The SolveSpace fi
To make, print both STL files, flat side down. You don't need any support. The part with the holes in it is the top. The small USB connector goes in the small hole, and the large USB programming connector sticks out the other end. The board will clip in, and then the bottom will clip onto the top half. You don't need any fasteners. The clips are a bit rough and you may want to tidy them up with a razor blade, but (at least for my printer) it all holds together pretty well.
It is faintly possible that Cypress might redesign the board and move the components around, in which case the support bars might be in the wrong place. If this is the case, please get in touch.
The SolveSpace fi
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!