D-BOT ATX PSU Bracket

Made in Onshape. This is to mount an ATX psu to the left rear corner (outside) of the D-Bot. You will need support on this one for sure. I will try to get pics to post once its mounted up and I know it all fits properly. This was my first print with the 0.8mm nozzle and 0.4mm layers. Pretty good results so far. notes: The screws into the ATX psu were a tiny bit out of alignment. No big deal, I simply wiggle them about until they caught threads, then heated the screw with the tip of my soldering iron. the hot screw pulled straight and once cooled the psu tightened up perfectly