Thingiverse
D-Bot custom corner bracket with holes
por brewpirate
29
Descargas
5
Likes
0
Makes
Modified version of [custom D-bot bottom corner
](http://www.thingiverse.com/thing:2072280) with holes added to attach feet to the threaded end of the vertical supports. For the feet I printed [M5 feet](http://www.thingiverse.com/thing:1398364) by: ThePhilStrongProject in Hatchbox TPU and attached with 18mm m5 screws. The secondary hole I used a 16mm M5 screw with a washer.
Sorry for the poor prints, I was experimenting with MakeShaper PLA/PHA and obviously my settings were not good. I will replace them at some point but they work for now.
](http://www.thingiverse.com/thing:2072280) with holes added to attach feet to the threaded end of the vertical supports. For the feet I printed [M5 feet](http://www.thingiverse.com/thing:1398364) by: ThePhilStrongProject in Hatchbox TPU and attached with 18mm m5 screws. The secondary hole I used a 16mm M5 screw with a washer.
Sorry for the poor prints, I was experimenting with MakeShaper PLA/PHA and obviously my settings were not good. I will replace them at some point but they work for now.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!