dōTERRA diffuser power brick

This is a project box sized to fit a doTERRA diffuser power circuit in.

Unfortunately we had a dud power pack shortly out of factory (which was quickly and easily replaced by doTERRA). Not wanting to waste it, I opened up to investigate and discovered that one of the mains connectors was faulty.

After attempting just to solder directly onto the broken pin I went about creating a replacement power brick from an existing project box on Thingiverse (https://www.thingiverse.com/thing:2477714 thanks cudatox) and modified it in TinkerCAD for cables and logo.

Also gives added bonus of slightly longer cable length for the sometimes awkward distances (which we had one of).