MakerWorld
Electronics
Voir le modèle
D1 Mini case with screen and optional sensor
49
Téléchargements
20
Likes
24
Makes
Build your own little D1 Mini Display! For this project, I've used a D1 Mini and a 1.5" 128x128 OLED display. Additionally, I connected an SCD40 CO2 sensor to measure the air quality, temperature and humidity in my office. This case is specifically made for the D1 Mini ESP8266 module and a 1.5" 128x128 OLED display. At the rear, there is a cutout for the USB port and a hole for wires, to allow the connection of external components. The display PCB has a size of 34 x 47mm. A case for the SCD40 CO2/temperature/humidity sensor is also included on a separate build plate. This breakout board with the sensor measures 23.6 x 15.45mm Assembly instructions If you want to add external components, put the wires through the hole in the back first. Connect the wires to the D1 Mini. Slide the D1 mini in its support. The side with the antenna should fit in the cutout. Put the display face down in the case lid. Then wire the display to the D1 Mini. Now, fit the D1 Mini in the case. The inside of the c
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !