Thingiverse
D20 Wall Art
door geoffreyyoung
3.8k
Downloads
2.3k
Likes
15
Makes
v2
Updates on 2023-04-01:
- Minor model updates, including edge tidying, bottom bevels, and a bit less plastic.
- Models are now multi-material friendly, with three parts: bottom, base, and number. You can see the parts in the silver/black/red model picture.
- Added a first pass at a base.
The silver/black/red v2 model was printed in ABS.
v1
Some wall art for all the DnD fans out there, including my daughter.
If you use the provided guides for spacing the end product is about 15" x 15" (38cm x 38cm).
I used Protopasta's Iron-filled Metal Composite PLA
https://www.proto-pasta.com/collections/metal-filled/products/magnetic-iron-pla
and rusted the pieces before sanding and polishing the tops. A light coat of spray polyurethane was added so the rust doesn't come off on fingers or the wall, but I'm honestly not sure if I like the way the coating looks (they were pretty cool looking with the rust showing, while the finish makes it look kind of painted on).
Updates on 2023-04-01:
- Minor model updates, including edge tidying, bottom bevels, and a bit less plastic.
- Models are now multi-material friendly, with three parts: bottom, base, and number. You can see the parts in the silver/black/red model picture.
- Added a first pass at a base.
The silver/black/red v2 model was printed in ABS.
v1
Some wall art for all the DnD fans out there, including my daughter.
If you use the provided guides for spacing the end product is about 15" x 15" (38cm x 38cm).
I used Protopasta's Iron-filled Metal Composite PLA
https://www.proto-pasta.com/collections/metal-filled/products/magnetic-iron-pla
and rusted the pieces before sanding and polishing the tops. A light coat of spray polyurethane was added so the rust doesn't come off on fingers or the wall, but I'm honestly not sure if I like the way the coating looks (they were pretty cool looking with the rust showing, while the finish makes it look kind of painted on).
geoffreyyoung publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
