Thingiverse
D300VS SaberTusk
door Lucidwolf
1
Downloads
0
Likes
0
Makes
Still was having issues with getting good bridges and overhangs at fast printing speeds so I decided to just go with brute force cooling with two 5015 fans .
Works like a champ, can work too well. Make sure your hot end has a sock and you re-calibrate your hot end. Also slowly ramp up in your G-code. I normally only run it at 40% unless doing some crazy overhangs or bridges.
For the lower screw I had to go up a grip length and used a spacer to get the right amount of thread for the mount.
Works like a champ, can work too well. Make sure your hot end has a sock and you re-calibrate your hot end. Also slowly ramp up in your G-code. I normally only run it at 40% unless doing some crazy overhangs or bridges.
For the lower screw I had to go up a grip length and used a spacer to get the right amount of thread for the mount.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
