Thingiverse
D6 holder Necromunda Pattern
von OblivionStar
100
Downloads
68
Likes
0
Makes
A Necromunda pattern version of my Dice holder
holds 25 x 16mm 6 sided dice,
Other material required:
-3M screws 10mm with nyloc nuts x 5
-some cord
-A cord lock toggle
the knot stopping the cord being pulled through the center hole is hidden under the bottom plate, use a lighter or something to partially melt the cord ends together and shrink it a little so it fits in the gap
print instructions:
all parts need support, i would advise at least skirt on the main body
maybe even on rafts depending on if you commonly get the "elephants foot" problem on your first few layers
the 2 ends are a couple of hours and the body is around 12hours
i print them at 0.2 layer and at least 3 walls
holds 25 x 16mm 6 sided dice,
Other material required:
-3M screws 10mm with nyloc nuts x 5
-some cord
-A cord lock toggle
the knot stopping the cord being pulled through the center hole is hidden under the bottom plate, use a lighter or something to partially melt the cord ends together and shrink it a little so it fits in the gap
print instructions:
all parts need support, i would advise at least skirt on the main body
maybe even on rafts depending on if you commonly get the "elephants foot" problem on your first few layers
the 2 ends are a couple of hours and the body is around 12hours
i print them at 0.2 layer and at least 3 walls
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!