D6 holder

holds 25 x 16mm 6 sided dice,

Other material required:
-3M screws 10mm with nyloc nuts x 5
-some cord
-A cord lock toggle

the knot stopping the cord being pulled through the center hole is hidden under the bottom plate, use a lighter or something to partially melt the cord ends together and shrink it a little so it fits in the gap

print instructions:
all parts need support, i would advise at least skirt on the main body
maybe even on rafts depending on if you commonly get the "elephants foot" problem on your first few layers
the 2 ends are a couple of hours and the body is around 12hours

i print them at 0.2 layer and at least 3 walls