Da Vinci GoPro Camera mount - Hero 2 Version

Wanted a quick and easy to remove Da Vinci Camera mount for my older Hero 2 Camera. Allows for GoPro BackPak for remote control if needed. Fits inside with door closed.

This is a 'fixed in place' version using the bed clamp from: http://www.thingiverse.com/thing:828083

and the GoPro Hero Frame Case by: http://www.thingiverse.com/thing:213280

Should work with XYZPrinting Da Vinci 1.0/1.0a/2.0
Done with Lightwave 11.6 and DaVinci 1.0a

NOTES: * REMOVE BEFORE CALIBRATION PROCEDURE *
(Also if you downloaded v2 that was the shorter prototype uploaded my mistake..Please use v2-1 to avoid impact during test strip printing)

New Version: PLUS 35 - Should fit without calibration issue

In Action: https://www.youtube.com/watch?v=bfkruL39vlQ