Thingiverse
Da Vinci Spool Holder
von Wangler
47
Downloads
33
Likes
1
Makes
Revision of original design, in order to allow for clearance for a 8" diameter Hatchbox spool.
Please note that it isn't fully enclosed; the solid wall facing the camera is only on this side of the holder...the other side shows the cutouts.
That solid wall could have been thicker...not doing much good as thin as it is.
Please note that it isn't fully enclosed; the solid wall facing the camera is only on this side of the holder...the other side shows the cutouts.
That solid wall could have been thicker...not doing much good as thin as it is.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!