Dagoma Neva spool support

Dagoma Neva printer spool support.
Attaches to the rods by clipping.
The bracket rotates about 60 °, and the coil is parallel to the machine to fall from the motor.
Do not forget to raise the supportfrom 2 to 3 mm above the tray so that it doesn't touch and doesn't perturb the calibrations.

Update 10/29/2017: Addition of the logo of the Neva on the fixed support and modification of the system of accoche. It is less difficult to set up and squeezes the stems less.

Update 05/15/2018: New support arm with holes to position a bumper where needed to limit the movement of the spool. The support is 3 cm longer and is reinforced.


Support de bobine pour Dagoma Neva.
Le support se clips sur les tiges acier.
L'axe tourne sur 60° pour s'aligner au coté de la machine afin de tomber face à l'entrée.
Ne pas oublier de rehausser le support de 2 à 3 mm au dessus du plateau afin qu'il ne touche pas et ne perturbe pas les calibrages.

Mise à jour 29/10/2017: Ajout du logo de la Neva s