Thingiverse
Daisy 901 Suppressor
door elliotsfar
17
Downloads
36
Likes
0
Makes
Update (2025):
I've added a thin version for those using the iron sight.
In both versions, I tested the fit on two guns. One fit perfectly, while the other required a small piece of tape to keep it snug.
Consider doing a split-model test print focused on the attachment area to ensure better compatibility.
---
Original:
Made this for my new Daisy Powerline 901 air gun (2024)
Barrel shroud diameter: 14.2 mm
Printed in PETG and no support when standing upright.
It blocks the iron sight a bit so best to use scope.
I think it will fit new 880 too. But somebody has to confirm this.
I am very surprised how well it works despite made of plastic.
I've added a thin version for those using the iron sight.
In both versions, I tested the fit on two guns. One fit perfectly, while the other required a small piece of tape to keep it snug.
Consider doing a split-model test print focused on the attachment area to ensure better compatibility.
---
Original:
Made this for my new Daisy Powerline 901 air gun (2024)
Barrel shroud diameter: 14.2 mm
Printed in PETG and no support when standing upright.
It blocks the iron sight a bit so best to use scope.
I think it will fit new 880 too. But somebody has to confirm this.
I am very surprised how well it works despite made of plastic.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!