Thingiverse

DAN

by procv

2 Downloads

4 Likes

0 Makes

REGULATOR CASING
I PURCHASED THE CHARGE CONTROL CIRCUIT BOARD ON BOB SA - XH-M602 TO CHARGE THE LI-ION BATTERIES OF MY E-BIKE AND I NEEDED A HOUSING FOR THE ELECTRICAL BOARD -SO I SAT DOWN AND PUT IT TOGETHER WITH TINKERCAD - MY CALIPER VERNIER,- RULER AND THE CIRCUIT BOARD IN HAND I THEN BUILT A DUMMY CIRCUIT BOARD STL FILE- TO CHECK INSIDE MEASUREMENTS OF MOUNTINGS IN THE CASE AND TO AID VENTILATION , THE REAR VENTILATED BACK BOARD SLIDES INTO POSITION AFTER THE BOARD HAS BEEN MOUNTED AND THE POWER SWITCH AND CONNECTOR SOCKETS HAS BEEN FITTED -AND 26 HOURS LATER - VOILA ......PRINTING
CIRCUIT BOARD, ELECTRICAL CIRCUIT, BATTERY CHARGER REGULATOR, LI-ION BATTERY, E-BIKE,
SPECS ON CIRCUIT BOARD = Battery Charger 18650 Li-ion (6-120V) Charger Controller Board XH-M602
Input Voltage: 220V AC
Charging Type: 6 - 120V Storage Battery Charger (Lead-acid, Nimh, Nicd, Li-ion)
Size: 86 x 58 x 24mm

Source

Thingiverse

What you need to print this: Beginner Medium confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format

STL

Material

Min. bed size

86 mm (Medium)

Est. print time

26 h

Software

Cura, PrusaSlicer, or similar

Same designer, more platforms

procv also publishes on

3 additional models across 1 more platforms

Cults3D

3 models

♥ 125 ↓ 2,778

Frequently Asked Questions

Which 3D printer is suitable for DAN?

Any FDM printer should handle DAN just fine. It's been printed on machines like Bambu Lab A1 Mini, Prusa Mini+, Creality Ender 3, most FDM printers. A minimum build volume of 86 mm is recommended.

How long does it take to print DAN?

According to the design notes, DAN takes approximately 26 hours to print at standard settings (0.2 mm layer height, 15% infill). Actual print time varies based on your printer speed, layer height, and infill density.

What file format is DAN available in?

DAN is available in STL format. These files can be opened and sliced using free software such as Cura, PrusaSlicer, Bambu Studio, or OrcaSlicer for FDM printing, or ChiTuBox and Lychee Slicer for resin printing. The download is provided through Thingiverse.

Is DAN free to download?

Yes, DAN is available as a free download through Thingiverse. Always check the license on the original platform to understand commercial use, remixing, and attribution requirements.

No ratings yet

No comments yet – be the first!

DAN

Add to Collection