Thingiverse
Dandelion Puller
von STIG_
2
Downloads
2
Likes
0
Makes
Using 3 perimeters, you should be able to get the equivalent of 100% infill. It has been field tested and i am able to first push about 3" deep then on the second stab, able to pry the dandelion out.
This is made to fit a 16mm wood rod i had laying around.
This is made to fit a 16mm wood rod i had laying around.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
