Thingiverse
DangerPumpkin (Original Sword design)
door CarlThePumpkinMan
3
Downloads
7
Likes
0
Makes
This is an original design I created in my early days of my 3D modeling journey. I revamped it to hopefully be much sturdier and easier to print. I recommend printing the crossguard, handle, and rods at 20%, and the rest at 5 or 10% for maximum sturdiness.
Showcase and build instructions down below!
https://www.youtube.com/shorts/tg2ax3bH4AM
https://www.youtube.com/watch?v=HC7oxg1RW5A&ab_channel=CarlThePumpkinMan
Showcase and build instructions down below!
https://www.youtube.com/shorts/tg2ax3bH4AM
https://www.youtube.com/watch?v=HC7oxg1RW5A&ab_channel=CarlThePumpkinMan
CarlThePumpkinMan publiceert ook op
285 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
