Dark angel II

Picture source/author: SandySarten @sandysarten It is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 150x150mm in size  You may print at higher layer heights below the Base Thickness of 0.56mm  The Max allowed Thickness is 2.08mm and the Actual Thickness is 2.08mm Filaments Used: PLA Elegoo+ Black Transmission Distance: 0.3 PLA Sunlu META Grey Transmission Distance: 3.6 PLA Elegoo + Gray Transmission Distance: 3 PLA Elegoo + White Transmission Distance: 6 This print uses 4 unique filaments Swap Instructions: Start with Black At layer #10 (0.88mm) swap to Grey At layer #14 (1.2mm) swap to Gray At layer #19 (1.6mm) swap to White for the rest.