Dark Saber

I printed this from a file that already exists.

The DARKSABER (a collapsing sword prop!) by yeetkus on Thingiverse: https://www.thingiverse.com/thing:4754462

I changed the orientation on a couple of the pieces. The end piece was rotated 180 degrees and the front (TOP) was placed with the rear (the part that connects to the middle part) on the build plate. I printed them one at a time due to my time constraints. I didn't print the small white pieces, I painted them instead.

The only problem I had was after I printed the blade pieces (again one at a time), I found that they would slide right out and not stop. I didn't re-print them, I just put about a 1/2 inch piece of masking tape wrapped around the end until it stopped. Seemed to work just fine.

I also wrapped a piece of masking tape around the end to hold it in place and not permanently glue it just in case I wanted to remove the blade for some reason.

The riser for the stand...in you slicer make it a mirror im