Thingiverse
Dart Case
von AHoj3D
147
Downloads
141
Likes
0
Makes
This is a case for my darts.
There is room for replacement tips in the front part.
It was printed in two parts.
The parts are connected with a 1.5 mm thick wire.
Furthermore, two magnets(size: 12.4x2.4x5 mm) are needed for the closure.
Finally, some foam is needed to fix the darts.
There is room for replacement tips in the front part.
It was printed in two parts.
The parts are connected with a 1.5 mm thick wire.
Furthermore, two magnets(size: 12.4x2.4x5 mm) are needed for the closure.
Finally, some foam is needed to fix the darts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
