Dartboard Wall Fixing

This post is an inspiration for people, who need to install their dartboard on a wall. I used [ZacSimmo's](https://www.thingiverse.com/zacsimmo/designs) design as base for my idea. Check him out, he made a couple of nice models.

How to print:
* 4x "Part_mount.stl"
* 1x "Wall_mount.stl"

For the installation i used:
* 1x 5x40mm Spax-Screw for the wall fixing
* 4x 4x20mm Spax-Screw for dartboard fixing

Place one dartboard fixing in its center, it is the counterpart of the wall fixing. The other three dartboard fixings are used to keep an equal distance to the wall. I installed them at an angle of 120° at the edge of the board.

Keep in mind that the board hangs lower (I measured 33mm) than the drilling in the wall.