Thingiverse
Darth Vader lamp
von hugoarchicad
20
Downloads
35
Likes
0
Makes
Hi there,
This is my Darth Vader inspired lamp.
I used a typo LED light which comes in two in a box for $19 Australian
I used Darth Vader black filament of course and about 3 hours in I changed the roll for a little bit of red then I went back to the black.
That touch is up to you but I think it brings the devil out of the lamp with that colour.
There is also a little cylinder which I glue to the end of the typo light which has a battery compartment near the bulb.
the light turns on when you pull the cord so i thought I would feed the light from underneath and the cylinder works as a stopper if you want it that way.
Otherwise have nothing, the hole is a tight fit so I had to warm up the lamp hole with boiling water then I fitted the typo light and its tight in there now.
I hope you enjoy it.
when you make it make sure to add photos.
thank you!!
This is my Darth Vader inspired lamp.
I used a typo LED light which comes in two in a box for $19 Australian
I used Darth Vader black filament of course and about 3 hours in I changed the roll for a little bit of red then I went back to the black.
That touch is up to you but I think it brings the devil out of the lamp with that colour.
There is also a little cylinder which I glue to the end of the typo light which has a battery compartment near the bulb.
the light turns on when you pull the cord so i thought I would feed the light from underneath and the cylinder works as a stopper if you want it that way.
Otherwise have nothing, the hole is a tight fit so I had to warm up the lamp hole with boiling water then I fitted the typo light and its tight in there now.
I hope you enjoy it.
when you make it make sure to add photos.
thank you!!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
